#SEQUENTIAL TAIL LIGHT KIT INSTALL#
#SEQUENTIAL TAIL LIGHT KIT MANUAL#

For LED lighting to function properly, vehicles that have a 2 prong OEM type turn signal flasher, a Low Current Flasher Module must be installed in place of the traditional turn signal flasher module. The kit is designed to work with OEM tail light housing and lenses as well as aftermarket components. There is no separate sequential lighting control module to mount and wire up. In addition, the kit includes a self-contained microprocessor and circuitry to enable a multitude of sequential lighting patterns. This includes low level running light illumination, brake light illumination, turn signal illumination, emergency flash and back-up lighting where applicable. The kits replace all the functionality of the light bulbs they replace. These kits incorporate high efficiency LED lights that increase tail light brightness, reliability and longevity. We feel these Dodge Challenger Sequential turn signal taillights are the best exterior modification you can make.The Classic Sequential Tail Light (CST) kits are direct retrofit and replacement for incandescent light bulbs in classic vehicles. Once you have completed these steps, go back to the 2008-2010 instructions and continue at Step 17. Insert the TAN/GREEN wire from the trunk switch into the hole of the new harness. Remove the dummy plug that's in the connector. Then fold the cover over.ġ6E) Remove the brown wire retainer from the 4-pin connector. Using a pair of pliers, squeeze the metal tab on the quick- splice until it is flush with the connector body. Using the supplied quick- splice, connect the BLACK/GREEN switch wire to the BLACK wire on the new harness. Replace the retainer above.ġ6D Find the new Tail Light Harness (Part A). 16B) Using a small screwdriver, remove the brown wire retainer from the connector on the OEM harness.ġ6C) Insert a small screwdriver at the terminal side to release the TAN/GREEN wire. Cut the BLACK/GREEN wire coming from the trunk switch. The connector will slide off leaving the retainer in the fixture.ġ6A) Refer to the pictures below. Follow the instructions for the 08-10 Challenger, and take these additional steps: 16) Remove the connector from the panel using a large screwdriver. If your car has this, you will need to move one wire and cut/splice one ground wire from your OEM harness to the new tail light harness. Some 2011+ Challengers have a trunk release button under the spoiler.

These lights will fit any 2008-2014 Dodge Challenger, including SE, R/T and SRT8.

#SEQUENTIAL TAIL LIGHT KIT MANUAL#

While other products offer you fixed timing or complicated manual adjustments, our electronics sense your Challenger's flasher speed and adjust the sequence timing for you. These harnesses feature sophisticated electronics that automatically adjust the sequencing speed to match the turn signal flasher in your car.

#SEQUENTIAL TAIL LIGHT KIT INSTALL#

This Challenger sequential tail light kit contains pre-wired, plug-in harnesses that install with no wire cutting or splicing of any kind! These 2008-2014 Dodge Challenger sequential taillight kits will convert the taillights on your 2008-2014 Dodge Challenger into Sequential Turn Signals. These 2008-2014 Dodge Challenger sequential taillight kits are sure to raise your Challenger to a new level. (2011 - 2014 Dodge Challenger Models require cutting) 2008-2014 Dodge Challenger Sequential Taillights Kit

Sequential tail light kit